Steinbach Poolrunner Twin - Page 26

Use the AUTOSTART button
12
to switch between the cleaning intervals. Before and after the start of
operation, the lit LED
16
indicates the currently selected mode. If no cleaning interval is active, all LEDs
blink or none of the LEDs of the LED display blink
16
.
- 1D repeats cleaning daily.
-
3D repeats cleaning every 3 days.
-
7D repeats cleaning every 7 days.
Time function
13
15
Use this function to set the running time.
Use the TIME button
13
to switch between the running times. After the start of operation, the LED
indicator
15
indicates the currently selected and active mode by blinking.
-
1H stops cleaning after 1 hour.
- 1.5H stops cleaning after 1.5 hours.
-
2H stops cleaning after 2 hours.
ON/OFF function
14
Use this function to switch the device on and off.
Use the ON/OFF button
14
to switch between the following functions:
-
ON switches the device on and starts cleaning at the same time.
- OFF stops cleaning and switches the device off at the same time.
26