3/96 5 - 1 09-282C
SERVICE section 5
SERVICE SCHEDULE
Daily:
•
Check for any signs of loose bolts and tighten as needed.
•
Check chipper knives and sharpen or adjust as needed. (See Page 5-2)
25 Hour:
•
In addition to daily service, remove belt shields and check drive belts for wear or cracking. Replace if
worn. (See Section 5.3)
•
Grease rotor bearings and drive shaft bearings.
100 Hour or Annual:
• Remove discharge shield and discharge screen and check rotor. Inspect chipper knives and shredder
sections for wear. Replace worn parts for efficient operation. (See Page 5-2 & 5-3)
Storage:
• Thoroughly clean the machine and store in a dry place to prevent rusting of rotor parts.
To Next Page
Loading...