Stelpro OASIS SOA Series - Installing the Fan Heater

3
IMAGE 1B'
INSTALLING THE FAN HEATER
TO ENSURE A SAFE AND EASY INSTALLATION, TAKE A FEW MINUTES TO READ THIS INSTALLATION GUIDE.
TOOLS REQUIREDWHAT IS IN THE BOX
Tool to cut drywall
or gypsum board
Level
Wire stripper
Cable clamp
OASIS FAN HEATER
Tape measure
Stud nder
Phillips screwdriverFlat screwdriver
4 to 6 No. 6 to No. 10 round-head wood screws
and suitable brackets to secure the fan heater
(4.3 kg or 9.4 lb) to the type of wall
2 capsWall mount support
For (A)SOA...W
(A)SOA...WCW models
For (A)SOA...PW model
FOR (A)SOA...W / (A)SOA...WCW MODELS
CONTROL AND COMPATIBILITY
You can control your OASIS fan heater in multiple ways:
SPECIFICATIONS
(A)SOA...WCW (A)SOA...W
SOA...PW
(WITH A POWER CORD)
Thermostat
MAESTRO thermostat or any other
compa tible wall thermostat that can
handle the fan heater’s power
Built-in electronic thermostat
Built-in electronic
thermostat
Power in NORMAL mode 1500 W
2000/1500 W or
1000/750 W*
1000 W 1000/750 W 1000 W
Power in BOOST mode N/A 1500 W 2000/1500 W 1500 W
Required voltage 120 V 240/208 V 120 V 240/208 V 120 V
Device weight 7.9 lb / 3.6 kg
Storage temperature -40 °C to 50 °C (-40 °F to 122 °F)
Operating temperature
-20 to 50 °C (-4 to 122 °F)
The eciency of the thermostat's built-in LCD display may be reduced below 0 °C (32 °F)
Relative humidity 5% to 95% without condensation
*Depending on power selector position.