How to fix a Stelpro Spider Heater that does not work?
If your Stelpro Heater isn't working, start by checking the circuit breaker or fuse. Also, inspect and repair any faulty connections. Then, make sure to reset the thermal protection. Finally, check the thermostat for any issues or incorrect settings.
Why does my Stelpro Spider trip the breaker?
If your Stelpro Heater trips the breaker when turned on, there could be a few reasons. First, inspect and repair any faulty connections. Second, ensure the voltage is within specified limits, as a voltage higher than that written on the nameplate can cause this issue.
What to do if my Stelpro Spider Heater doesn't reach the desired temperature?
If the desired room temperature cannot be reached with your Stelpro Heater, it could be due to several factors. First, inspect and replace any defective elements. Second, check the thermostat for proper settings. Third, ensure the voltage supply matches what's on the nameplate. Lastly, reduce heat losses in the room, as they might be higher than the unit's capacity.
Why does my Stelpro Spider run continuously?
If your Stelpro Heater is running continuously, it might be due to a defective thermostat or incorrect thermostat setting. Check the thermostat to ensure it's working correctly. Also, the heat losses might be higher than the unit's capacity, so try to reduce heat losses in the room.
Why is my Stelpro Spider Heater overheating the room?
If your Stelpro Heater is causing the room to overheat, the most likely cause is a defective thermostat or an incorrect thermostat setting. You should check the thermostat to resolve this issue.
Why is the enclosure of my Stelpro Spider Heater extremely hot?
If the enclosure of your Stelpro Heater is extremely hot, it could be due to a few reasons. First, a defective thermal protection might be the cause, so replace it. Second, the motor could be defective, requiring replacement. Finally, check for and clear any blocked air vents.
What causes Stelpro Heater to cycle under thermal protection?
If your Stelpro Heater cycles under control of the thermal protection, it's likely due to blocked air vents. Clear the blocked air vents to resolve this issue.
Specifies the ideal wattage per cubic foot for optimal heating performance.
Details steps for mounting the unit, making electrical connections, and securing covers.
Instructions for regular cleaning to maintain unit performance and warranty validity.
Identifies common issues and suggests checks for defective parts or settings.
Lists part numbers and descriptions for components that may need replacement.
Outlines the steps to follow for making a warranty claim, including required documentation.
Details conditions, exclusions, and limitations of liability covered by the warranty.
General| Type | Electric baseboard heater |
|---|---|
| Color | White |
| Voltage | 240V |
| Control | Electronic thermostat |
| Mounting | Wall mounted |
| Safety Features | Overheat protection |
| Thermostat | Integrated electronic thermostat with precise temperature control |
To Next Page
