Maintenance Manual STEMME S10
Date of Issue: Oct. 1, 1990 page: 23
Amendment No.: 18 Date: Oct. 15, 2012
A4010021_B19.doc
Doc.No.: A40-10-021
5. Time Limits / Maintenance Checks
5.1 Life-Limited Components
For Life limited parts refer to the Airworthiness Limitations section of the manufacturer documentation
(applicable Maintenance Manual, Service Bulletin etc.) for permissible service life limits prescribed by the
respective manufacturer. These items must be entered in the form Review of Operating times.
5.2 Pre- Flight Checks
See Flight Manual.
5.3 Periodical Checks, Inspection Lists
The intervals for general maintenance tasks depend on operating conditions, climate, stowage, etc.
Notwithstanding the above mentioned conditions, however, at least the following periodical checks are to be
performed:
Type 1a after the first 25 operating hours
− Type 1b after the first 50 operating hours and every further 50 operating hours
− Type 2 after the first 100 operating hours and every further 100 operating hours
− Type 3 annually
The items to be checked are given in the following "Inspection Lists for Periodical Checks".
In addition, special inspections which may be prescribed by the manufacturer or by the airworthiness authority
are to be performed in accordance with the directives issued.
Unscheduled Maintenance for propeller assembly, engine drive section and reduction gear components:
An unscheduled overhaul or replacement additional to expiration of the stated time limit is necessary in each
case of:
• Impact stop (possible ground touch of the propeller);
• Non- observance of the periodical inspections as they are fixed in the Maintenance Manual,
In case of damaging by ground contact, bird strike, stone strike or similar which require a „large repair“, the
manufacturer decides which parts of the complete drive system are affected and if a repair may be
practicable or if an overhaul or replacement has to be performed.
To Next Page
Loading...
Need help?
General
