Need help?Do you have a question about the Steris Reliance 1227 and is the answer not in the manual?
Manual's purpose, safety precautions, and general information for operating the washer/disinfector.
Important safety precautions, intended use limitations, and notes on warranty voiding alterations.
Introduces the importance of safety precautions for safe operation and servicing.
Details specific warnings and cautions for personal injury and equipment damage.
Warns about pinch points, hot surfaces, and moving parts, stressing PPE use.
Guides on safe use of chemicals, PPE, and emergency actions for exposure.
Warns about hot surfaces and steam, advising caution and PPE when entering the chamber.
Advises on proper reinstallation of star washers for bonding continuity.
Recommends keeping floors dry and cleaning spills promptly.
Defines common symbols found on the washer/disinfector and in the manual.
Defines symbols typically found on the equipment's identification nameplate.
Provides an overview and identifies the main components of the washer/disinfector.
Describes the removable debris screen and its function in preventing piping system clogs.
Explains the function and design of the horizontally mounted spray arms.
Describes the guiding rail's purpose in guiding racks and aiding drying.
Details the components housed within the mechanical core of the washer/disinfector.
Locates the electrical box and its contents (CPU, controls).
Details the chemical injection pumps and their use with concentrated chemicals.
Explains the function of air filters for preventing load contamination.
Provides general steps and warnings before operating the washer/disinfector.
Provides safety warnings and notes on door operation.
Provides safety warnings and guidelines for loading racks.
Provides safety warnings and general guidelines for loading the washer/disinfector.
Explains how to monitor cycle progress and view cycle data.
Provides warnings and steps for unloading the washer/disinfector.
Explains how to put the washer/disinfector into Standby mode to save resources.
Explains how to respond to warning messages displayed on the touch screen.
Details how to respond to alarms, which stop the cycle immediately.
Provides instructions on how to stop or abort a cycle.
Details the procedure for using emergency stop pushbuttons.
Details the procedure for using emergency stop cables inside the chamber.
Introduces Supervisor mode and how to access it via login.
Explains adding, editing, or deleting supervisor login names and passwords.
Explains creating customized cycles and modifying existing ones.
Emphasizes scheduled preventive maintenance by STERIS technicians.
Provides a guide for routine maintenance frequencies and procedures.
Provides warnings and steps for cleaning the debris screen.
Provides warnings and recommendations for performing the DECONTAM cycle.
Provides general warnings and describes the troubleshooting section's content.
Describes condition and troubleshooting steps for Emergency Stop alarms.
Describes condition and troubleshooting for incomplete drying.
Describes condition and troubleshooting for loads coming out dirty.
Lists part numbers for replacement parts and consumables.
To Next Page
General
