20
press the PRINT key to enter parameter setup.
*If the "diSAbLEd" message is
displayed, remove the J3 jumper on the 780-001 digital board to enter parameter
setup.
Step 2: The "SEtuP 01" message will now be displayed. Enter the number of
the parameter you wish to modify on the keypad and press the PRINT key. (You
may also step through all parameters by pressing the PRINT key repeatedly).
Step 3: The parameter symbol and the current parameter value will be
displayed. Select from the options available for the parameter by pressing the
SCALE SELECT key till the required value is displayed.
Step 4: Press the PRINT key to enter the desired symbol or value and go to
the next parameter.
Step 5: Press the RESET key to exit parameter setup.
To Next Page
Loading...