3
INSTALLATION
The XC780 is shipped to you complete with all options installed. Upon receipt,
check the packaging for shipping damage and report any damage to your carrier.
In the package you should find:
1 XC780 with options installed
1 External Power Supply
1 Platter Support assembly
1 Platter
1 Hardware kit(mounting screws, spare fuse, cable clip,
capacity label, jumpers, etc.)
1 XC780 Manual
1 Battery Pack(if purchased with the Battery Operation
option)
Carefully unpack all contents, saving the packing material for storage or
transportation later. If any of the contents are missing, contact your dealer
immediately. (If the Battery Operation option was not purchased, the battery
pack space in the shipping package will be empty).
The XC780 is shipped with the platter assembly disconnected to avoid load cell
damage during shipping. The assembly is quite simple.
WARNING:
DO NOT APPLY EXCESSIVE DOWNWARD,UPWARD, OR TWIST PRESSURE ON THE LOAD
CELL WHEN WORKING WITH THE PLATTER ASSEMBLY!!! THIS COULD CAUSE LOAD CELL
DAMAGE.
Installation:
1. Set the XC780 on a flat level surface.
2. If the built-in scale is used no load cell wiring will be necessary. If an
external load cell is connected to the XC780, remove the dust cover and connect
the load cell cable to the seven pin load cell input terminal block(P6) as
shown in figure 1. The pins are labeled on the analog board:
Pin 1 +EX +Excitation Voltage(10 VDC)
Pin 2 +SEN +Sense line for external sensing(remove
J1,J4 if sense used)
Pin 3 +SIG +Signal line
Pin 4 -SIG -Signal line
Pin 5 -SEN -Sense line for external sensing(remove
J1,J4 if sense used)
Pin 6 -EX -Excitation Voltage(GND)
Pin 7 Shield Shield connection
To Next Page
Loading...