9
value on the keypad and press the SHIFT key followed by the [1]|SP1 key. To
review the entered value press the SHIFT key follow by the [1]|SP1 key without
entering any data. See the section on "Setpoint/Comparator Operation" for more
information.
SP2:
The SP2 key is used to enter and view data for setpoint 2 and
the high cutoff for the comparator. To store a value, enter the
setpoint/cutoff value on the keypad and press the SHIFT key followed by the
[3]|SP2 key. To review the entered value press the SHIFT key follow by the
[3]|SP2 key without entering any data. See the section on "Setpoint/Comparator
Operation" for more information.
F1:
The F1 key is used to display the Percent Accuracy expected
from the current piece count sample. After sampling a part, press the SHIFT
key followed by the [2]|F1 key to display the minimum percent accuracy. If the
value is too low, re-sample using more parts. See "Piece Count Operation" for
more details.
F2:
Reserved for future use.
ANNUNCIATOR LIGHTS:
kg:
The kg lamp is on when the XC780 is displaying weight in
kilograms(kg).
g:
The g lamp is on when the XC780 is displaying weight in
grams(gr).
lb:
The lb lamp is on when the XC780 is displaying weight in
pounds(lb).
pcs:
The pcs lamp is on when the XC780 is displaying the
number of pieces(pcs).
SET1:
The SET1 lamp is on when the value of setpoint 1 has been
exceeded.
SET2:
The SET2 lamp is on when the value of setpoint 2 has been
exceeded.
OVER:
The OVER lamp comes on when the weight or count is over
the upper limit of the comparator set by SET2.
UNDER:
The UNDER lamp comes on when the weight or count is under
the lower limit of the comparator set by SET1.
ADD:
The ADD light comes on during piece counting when the
sample size used is too small(less than "PCT " percent
full scale capacity as set in parameters).
To Next Page
Loading...