4
Figure 1
3. If an external remote scale base is to be connected, do so now following
the instructions described in the "Remote scale input option" section of the
XC780 Technical Manual.
4. Position the platter support assembly on the load cell as shown in figure
2.
5. Insert the 1/4 20 x 1 1/4" screws into the mounting holes and tighten
firmly but not excessively (40 to 60 inch-pounds of torque).
WARNING!! Do not press DOWN on the load cell screws with more force than the
capacity of the cell. The overload stops will not protect the cell when the
screws are loose.
Figure 2
6. Mount the platter to the platter support assembly by lining up the pins on
the bottom of the platter with the grommets on the platter support. The
platter should slide into place. See
figure 3.
7. Connect any external printer or computer cables required.
8. Connect the AC/DC adaptor to the input plug in the back of the XC780. The
clip supplied in the hardware kit may be used to hold the cable in place so it
cannot be accidentally removed. See figure 3.
9. Be sure that the input voltage on the AC/DC adaptor matches the ac power
used. Plug the AC/DC adaptor into a suitable ac wall plug. The AC/DC adapter
is specially selected for the XC780, another power supply may not perform as
well.
To Next Page
Loading...