5
10. Turn the power switch located on the back of the XC780 to on(the switch
will show red when on).
11. The XC780 will run through a display check(all display segments on), an
internal self test, and then be ready for use. (For maximum accuracy, the unit
should be allowed to warm up for five minutes)
Note: Each XC780 is pre-calibrated at the factory for the built in scale. If
an external scale base is connected or the unit displays incorrect weight,
please consult the chapter on "Calibration Setup".
Note: If the XC780 is to be used in a potentially high static area, such as
plastic filling or counting, special precautions MUST be taken. See the
section on "Static Protection" for more information.
To Next Page
Loading...