STERWINS 40VLM2-46SP.1 - Troubleshooting Common Problems

207
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
7.5 TROUBLESHOOTING
DANGER ! RISK OF INJURY DUE TO ELECTRIC SHOCK.
BEFORE ANY TROUBLE SHOOTING, SWITCH OFF THE PRODUCT.
Problems Probable causes Solutions Qualification
Product does
not start
Battery is not secure
To secure the battery
pack, make sure the
latches on the top
of the battery pack
snap into place
-
Battery is not charged
Charge the battery
pack according to the
instructions included
with your model
Power/speed switch is
in the OFF position
Press the on/o switch
Battery pack not
properly attached
Attach properly
On/o switch not set
on ON position
Refer to chapter
“Start the product”
The handle is not
correctly fitted
The panel bolts are not
correctly inserted
Adjust the height of
the handle and check
that the panel bolts
are correctly inserted
-
The quick-fastening
levers are not tightened
Tighten them
The mower cuts
unevenly
The grass is not uniform or
thick, or the cutting height
was not correctly adjusted
Check the height of
the wheels. All the
wheels must be set
to the same cutting
height so that the
mower can cut evenly
-
Mulching is not
done correctly
The grass cuttings are
damp and sticking
to the mower
Wait for the lawn to
dry before mowing
-
The mower is
dicult to push
The grass is long, the
rear panel of the mower
and the blade are
dragging in very dense
grass, or the cutting
height is set too low
Raise the cutting height -
The grass cuttings
are not collected
properly in the
grass box
The cutting height
is too low
Raise the cutting height -