EasyManua.ls Logo

STERWINS 40VLM2-46SP.1 - Troubleshooting Critical Issues and End of Life; Critical Issues and Solutions; End of Life Disposal

STERWINS 40VLM2-46SP.1
226 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
208
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Problems Probable causes Solutions Qualification
The mower vibrates
at high speed
The blade is out of
balance or worn
Change the blade -
The motor shaft is twisted
Turn o the motor and
inspect the mower. Get
the mower repaired.
Aproved
repair center
The motor stops
while mowing
The cutting height
is too low
Raise the cutting height
-
The battery is discharged Recharge the battery
Mower suddenly
stopped while
cutting grass.
Mower maybe
occur overload
Stop the mower and
wait for minutes
to restart.
Product does not
reach full power
Battery pack
capacity too low
Charge battery pack
-
Air vents are blocked Clean the air vents
Vibration or noise
is excessive
Bolts/nuts are loose Tighten bolts/nuts -
Product suddenly
stops
Battery pack discharged
Remove and charge
battery pack
-
Battery too hot
Remove battery pack
and let it cool down
7.6 FATAL CIRCUMSTANCES : CRITICAL ISSUES
Problems Solutions
The machine smokes
during operation
Immediately stop the machine, then
speak to service center
The machine starts to
vibrate abnormally
Stop the machine, remove the safety key and
check immediately for the cause. check the
state of the blade. High vibration is generally
a warning of trouble, if no root cause is found,
bring the mower to the repair center.
8. END OF LIFE
Electrical products should not be discarded with household products. Used electrical
products must be collected separately and disposed of at collection points provided
for this purpose. Talk with your local authorities or dealer for advice on recycling.

Related product manuals