STERWINS A061003 - Page 264

1. SAFETY INSTRUCTIONS
of the machine.
gFor rotary tillers, ensure that only replacement cutting systems of
the right type are used.
gIf the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualied persons in
order to avoid a hazard.
gReplace worn or damaged parts for safety. Use only genuine
replacement parts and accessories.
gWhen servicing the blades be aware that, even though the power
source is switched o, the blades can still be moved.
gIf the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualied persons in
order to avoid a hazard.
gThe extension cable, plug and socket must be watertight and
intended for outdoor use.
gAlways allow the machine to cool down before storing.
gWhen you want to store the tool:
- Loose the quick release lock system on handles
- Fold the handles as shown in the illustration Store it.
gThe machine should be supplied via a residual current device (RCD)
with a tripping current of not more than 30 mA.
gMake sure that air circulation is adequate and good. The product
must be easily accessible from all sides.
gDuring transportation of the product, the operator must control
the handles by two hands.
Caution: An inadequate extension cable can be dangerous and can
cause accidents. Please contact a qualied electrician for advice if in
any doubt.Replace worn or damaged parts for safety.
261
FR
IT
EL
PL
RU
EN
ES
PT
KZ
UA
RO