CAUTION: Do not install the grass collection box if you intend to side ejection.
Lift up the side discharge door.
Place the hooks found on the side chute
10
into their respective grooves underneath the
hinges of the side discharge door. If correctly installed, the side chute
10
should be positioned
approximately parallel to the ground.
Let go of the side discharge door.
Installing the side chute-side ejection
5. OPERATION
Risk of death by electrocution or electric shock or serious personal
injury if power lines or electric cords are contacted. Never operate
mower over electrical sources, cords, or wires.
DANGER! Risk of injury due to electric shock.
Warning! Do not plug in before installation is fully completed!
Caution! Do not touch rotating blade!
Set up the lawn mower on at and rm ground to ensure safe and sturdy operating.
Rotate the upper handle
4
into its operating position.
Line up the holes on the bottom of the upper handle
4
with the holes on the top of the lower
handle
6
.
From the outside of the upper handle
4
, slide the bolt through the holes.
Slide the washer over the bolt of the lever and loosely assemble the entire assembly with the
knobs
5
.
Close the knobs
5
. If it is too tight or too loose, open the the knobs
5
to adjust the
clamping. Check the knobs
5
by closing them. They should be tight enough so the handles
are held rmly, but loose enough so the knobs
5
can be fully closed. Adjust by opening and
turning the knobs until the handles are secured. Hold the bolt by pushing with your hand and
rotate the knob with a little bit force.
There are four dierent holes three contiguous holes are for handle height adjustment. The
separated hole is for vertical storage on the side of the lower handle
6
to vary the height.
If the height seems too tall or too short, adjust the hole through which this locking knob is
placed accordingly.
Setting up your lawn mower
Adjust the handle height
229229
FR
IT
EL
PL
RU
EN
ES
PT
KZ
UA
RO
To Next Page
Loading...
