STERWINS PLM1-51H170.6 - Troubleshooting Guide

FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
247246
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
POS DESCRIPTION
95 Cap Nut
96 Knob
97 Locking handle bolt
98 Compression piece
99 Locking handle
100 Cylindrical pin
101 Cable fixing block
102 Drive cable assembly
103
Flameout cable
assembly
104 Upper handle
105 Handle sleeve
106 Self drive control bat
107 Brake control bar
108 Grass catcher handle
109 Self-tapping screw
110 Lever indicator
111 Grass catcher cover
112 Self-tapping screw
113 Grass catcher bracket
114 Grass catcher
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
7.5 TROUBLESHOOTING
HAZARD ! RISK OF INJURY DUE TO ELECTRIC SHOCK.
BEFORE ANY TROUBLE SHOOTING, SWITCH OFF THE PRODUCT.
Problems Probable cause Solutions Qualification
Excessive noise
The chain is dull /
damaged
Sharpen it or change it
by a new one
CUSTOMER
Nuts / screws are not
well tight
Screw the nut(s) /
screw(s)
CUSTOMER
The blade is not enough
set
Screw the nut(s) /
screw(s)
CUSTOMER
Gasoline leak
There is a leak of gasoline
from to a defective
assemblying (drilled pipe/
bad connection)
Find the leak location
and replace the part by
a new one
AFTER SALES
SERVICE
No engine start
The priming bulb has not
been pressed enough
Press the priming
bulb until the gasoline
is visible inside (4-7
times)
CUSTOMER
The spark plug is dirty
Remove and clean the
electrode with a spark
plug brush (iron bristle
brush)
CUSTOMER
The spark plug spring
doesn't match with the
plug
Remove and change
the spark plug by a
new one
CUSTOMER
The spark plug is
defective
Check is the spring
is still on the cap.
Otherwise change it by
a new one
CUSTOMER
The engine is flooded
Close the starter,
remove the spark plug,
clean the spark plug,
return the machine
and pull the rope 5 to
10 times to empty the
cylinder of gasoline
CUSTOMER