FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
249248
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Problems Probable cause Solutions Qualification
No engine start
The gasoline pipe is
drilled
Remove it and change
it by a new one
AFTER SALES
SERVICE
The carburetor is not well
adjusted
Resume the carburetor
setting procedure from
the beginning
AFTER SALES
SERVICE
The carburetor is
defective
Test it and change it by
a new one
AFTER SALES
SERVICE
The gasoline strainer is
not well placed (on the
bottom)
Check its position or
replace it
CUSTOMER
The starting cable is too
long
Change the cable
AFTER SALES
SERVICE
The switch is on OFF
position
Put the switch on ON
position
CUSTOMER
No engine stop
The OFF switch is
defective
Test it and change it by
a new one
AFTER SALES
SERVICE
The starting cable is too
short
Change the cable
AFTER SALES
SERVICE
The brake system is
defective
Test it and change it by
a new one
AFTER SALES
SERVICE
The trigger system is
defective
Test it and change it by
a new one
AFTER SALES
SERVICE
overconsumption
Carburetor is not well
adjusted /
Resume the carburetor
setting procedure from
the beginning
AFTER SALES
SERVICE
The engine doesn't
go to the idle
speed
Gasoline filter is blocked Replace it by a new one
AFTER SALES
SERVICE
The carburetor idle speed
screw is not well adjusted
Resume the carburetor
setting procedure from
the beginning
AFTER SALES
SERVICE
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Problems Probable cause Solutions Qualification
The engine lacks
of power
The air filter is dirty
Clean it or replace it by
a new one
CUSTOMER
The spark plug is dirty
Remove and clean the
electrode with a spark
plug brush (iron bristle
brush)
CUSTOMER
The gasoline filer is
blocked
Replace it by a new one
AFTER SALES
SERVICE
The carburetor speed
screw is not well adjusted
Resume the carburetor
setting procedure from
the beginning
AFTER SALES
SERVICE
No advancement
The advancement system
does not work
Check the self
propelled cable
AFTER SALES
SERVICE
The advancement system
does not work
Change the self
propelled gearbox
AFTER SALES
SERVICE
Advancement
doesn't stop
The advancement system
does not stop
Change the self
propelled gearbox
AFTER SALES
SERVICE
Unwanted smoke
The sealing between
gasoline and oil tank is no
Replace the motor by a
new one
AFTER SALES
SERVICE
Vibration
Nuts / screws are not
well tight
Screw the nut(s) /
screw(s)
CUSTOMER
7.6 FATAL CIRCUMSTANCES: CRITICAL ISSUES
Problems Solutions
The machine smokes during operation
Immediately stop the machine, then speak
to service center
8. END OF LIFE
Electrical products should not be discarded with household products. Used electrical
products must be collected separately and disposed of at collection points provided for
this purpose. Talk with your local authorities or dealer for advice on recycling.
To Next Page
Loading...
