STERWINS UP20 - 6. Wintering & Storage; Store the Machine; Store the Lithium Batteries

To Next Page

To Previous Page

208

7. MAINTENANCE

7.1 CLEANING

WARNING ! DO NOT HANDLE CUTTING PARTS WITHOUT GLOVES

AS THEY ARE SHARP AND CAN BECOME HOT AFTER USE,

POTENTIALLY CAUSING PERSONAL INJURY.

Cleaning the product: illustration

5.1

5.8

Let the machine cool for 2 hours outside before cleaning it. Remove the guide bar and the

saw chain. Clean the cover plate with a brush. Clean the area under the cover plate, the drive

sprocket and chain bar assembly using a soft brush. Clean oil outlet with a dry cloth.

Keep all safety devices, air vents, and motor housing free of debris and dirt. Wipe down the

equipment with a cloth. It is highly suggested that you clean the device after every use. Do not

use cleaning agents, as these can attack the plastic and weaken the structural integrity of the

product.

7.2 REPLACEMENT

When servicing, use only identical replacement parts. Use of any other parts may create a

hazard or cause product damage. If you shall replace the cutting blade, make sure that the

following characteristics are the same : same shape, same length, same thickness, same

weight, same material.

The following part of this product may be replaced by the consumer.

→ Saw chain

→ Guide bar

Other spare parts are available at an authorised dealer or through our customer service.

7.3 MAINTENANCE SCHEDULE

Part Action

Before/

After each

usage

Every

10H

Every

Chain

Check

Clean

Change

When it's necessary / Refer

to trouble shooting

Oil

Sharp

Guide Bar