STIEBEL ELTRON AQ 35 E-2 - Set Unit to Upside down (Turn 180 ˚) Direction

11
3.2) Set unit to upside down (turn 180 ˚) direction
Simulate like a unit working by activate Flow Switch (Reed SW.) become close circuit.
Check
Result
Cause
Action
Pole - Pole
"Beep" signal or (~ 0 )
Pass
No action
No signal "OL" or ( 
Reed SW contact closed
Change new one*
Remark: "OL" = Over Load for Digital Multimeter, " Multimeter
*Note: Recommend replacing magnet set at the same time.
Pole - Pole