STIEBEL ELTRON
8
1. Operation Instruction for the user and the qualied installer
1.7 Regulations and Provisions
- Regulations of the local power supply
authority should be observed.
- Regulations of the water supply
authority should observed
- Technical data.
- Install the unit flush with the wall.
- Electrical connection to be secure.
The unit must be earthed
(see circuit diagram). To protect
against water penetration, the cable
seal (Fig. 8 No.2) must be used.
1.8 Important note
All the information in these
operating
and Installation
Instructions must be carefully followed.
These instructions provide important
details regarding the
safety, operation,
installation, and maintenance
of the unit.
1.9 Installation location
The shower unit is to be installed
in a closed, frost-free room (discon-
nected
units are to be stored in a frost-
free location, since there will always be
some water left in the unit).
The AQ is to
be installed vertically on a wall (hot water
connection downwards).
1.10 First operation (Only to be carried
out by a qualified installer)
Before switching on, set the rotary
water valve to “Max” setting until
the pipework and the unit are free of air.
- Before switching “ON”, set the rotary
temperature control to “OFF”
- Check the operation of the water
heater.
Handing over the unit
Explain to the user how the unit works
and familiarise him or her with its use.
- Advise the user about possible
hazards (high water temperature)
- Hand over these instructions, to
be kept in a safe place.
1.11 Service note
When carrying out any work,
isolate the unit from the mains
and shut off the water connection.
- Clean the filter
Disconnect water valve remove filter
(Fig. 8 No.14) and clean.
Re-assemble in reverse order.
To Next Page
Loading...
