STIEBEL ELTRON AQ 35 E-2 - Guarantee; Fault Elimination for the User

STIEBEL ELTRON
9
For guarantees please refer to the
respective terms and conditions of
supply for your country.
The installation, electrical
connection and first operation
of this appliance should be carried
out by a qualified installer.
The company does not
accept liability for any failure
caused by improper installation and /
or unauthorized installers.
Any other use beyond that described
shall be deemed inappropriate. Obser-
vation of these instructions and of
instructions for any accessories used is
also part of correct use of this appliance.
2. Guarantee
3. Fault elimination for user
Fault Cause Rectification
No hot water despite flow
volume setting at right-hand
stop.
The water flow volume
required for the unit to
turn on has not been
reached.
- The shower head is
blocked with dirt or
limescale.
- Flow volume too low.
- ELSD activated
- Clean shower head
or remove limescale.
- Increase flow volume.
- Press “Reset” button.
The unit is not being switched
on. Electricity supply and flow
available.
The water flow volume
required for the unit
to turn on has not been
reached.
- Filter in the cold water
connection pipe
blocked with dirt.
- Water pressure not
enough
- Clean the filter after
shutting off the cold
water intake.
- Increase mains
pressure