INSTALLATION
Installation
ENGLISH
www.stiebel-eltron.com CK 20 Trend LCD | 23
12. Installation
12.1 Wall mounting
Note
Secure the wall mounting bracket with the tab cut-out
pointing upwards.
Note
Use appropriate fixing materials.
D0000069454
1
1 Wall mounting bracket
f Mark out the holes to be drilled for the wall mounting brack-
et on the wall. Use the wall mounting bracket as a template
for this purpose.
f Drill the holes.
f Secure the wall mounting bracket horizontally to the wall
with suitable rawl plugs and screws.
Note
The horizontal and vertical slots enable an adjustment in
case the fixing holes are not quite where they should be.
12.2 Appliance installation
D0000069513
1
1 Wall mounting bracket
f Hook the appliance with the upper vertical recesses of the
back panel onto the wall mounting bracket.
D0000069454
1
2
1 Through hole for locking screw
2 Locking screw
f Mark out the hole to be drilled for the locking screw. Use the
through hole in the lower section of the appliance casing as a
template for this purpose.
f Remove the appliance from the wall mounting bracket.
f Drill the hole for the locking screw. Insert a suitable rawl plug.
f Hang the appliance as described on the wall mounting bracket.
f Secure the appliance with a suitable screw.
12.3 Fitting the towel holder (accessories)
f Carefully pull the ends of the towel holder apart.
D0000059980
1
1 Towel holder mounts
f Insert the left and right-hand ends of the towel holder into
the mounts provided for this purpose at the back of the
appliance.
D0000059981
1
1 Towel holder, installed
!
CAUTION Injury
- Never hang any heat-sensitive or highly flammable
materials (e.g. textiles made of silk, wool or syn-
thetic fibre, paper) over the towel holder.
- Only heat/dry textiles that have been washed in
water (not dry cleaning).
To Next Page
Loading...
