www.stiebel-eltron.com DEM | 41
INSTALLATION
Installation
Route the power cable through the cable entry in the back
panel.
Hook in the appliance cover with the heater at the bottom.
Click the heater into place using the snap fastener.
Secure the appliance cover with the cover fixing screws.
Tap installation
Install the tap. For this, also observe the tap operating and
installation instructions.
!
Material losses
When making the connections, counter the torque
on the appliance using a size 14 spanner.
Pressure-tested tap
Note
Fit the 3/8 connection hose provided and the 3/8 tee.
10.2.2 Oversink installation, non-pressurised, with non-
pressurised tap
26�02�05�0081�
Tap installation
Install the tap. For this, also observe the tap operating and
installation instructions.
!
Material losses
When making the connections, counter the torque
on the appliance using a size 14 spanner; see chap-
ter "Installation alternatives/ Undersink installa-
tion".
293811_DEM 3-7_de_en_fr_nl.indb 41 11.10.2017 13:34:52
To Next Page
Loading...
