STIEBEL ELTRON DHCE 6/50 - Installation Preparation

Fig. 9 Fig. 11
Fig. 10 Fig. 12
(concealed connection)
STIEBEL ELTRON
12
Installation Instruction for the qualied installer
Installation
Preparation before installation of the unit:
- Before taking any action, always
switch o the water heater’s main circuit
breaker rst.
- Place a drilling guide at the drilling
position in order to drill a hole in the wall
(Fig. 6).
- Insert a wall plug and screw in (the
depth of the protruding screw head must
be correct) (Fig. 6 No.3).
- Remove the screw from underneath
the water heater to open the cover of the
unit.
.
- Open the cover of the unit.
- Remove the plug connecting the
cover of the unit.
- Inspect the internal components.
The cable must be in good condition,
- Create an opening for the water
inlet in the case of wall-embeded and
wall-mounted pipes.