STIEBEL ELTRON FEK 2 - Operation; General Information; Relevant Documents; Safety Instructions

10 | FEK 2
CONTENTS | OPERATION
General information
OPERATION
1. General information
The chapter "Operation" is intended for appliance users and
qualied contractors.
The chapter "Installation" is intended for qualied contractors.
Note
Read these instructions carefully before using the ap-
pliance and retain them for future reference.
Pass on the instructions to a new user if required.
1.1 Relevant documents
 Operating and installation instructions for the WPM
heat pump manager
 Heat pump operating and installation instructions
1.2 Safety instructions
1.2.1 Structure of safety instructions
KEYWORD Type of risk
Here, possible consequences are listed that may re-
sult from failure to observe the safety instructions.
 Steps to prevent the risk are listed.
1.2.2 Symbols, type of risk
Symbol Type of risk
Injury
1.2.3 Keywords
KEYWORD Meaning
DANGER Failure to observe this information will result in serious
injury or death.
WARNING Failure to observe this information may result in serious
injury or death.
CAUTION Failure to observe this information may result in non-se-
rious or minor injury.
OPERATION
1. General information ������������������������ 10
1.1 Relevant documents _________________________ 10
1.2 Safety instructions __________________________ 10
1.3 Other symbols in this documentation ___________ 11
1.4 Units of measurement _______________________ 11
2. Safety ������������������������������������ 11
2.1 Intended use _______________________________ 11
2.2 General safety instructions ____________________ 11
2.3 Test symbols _______________________________ 11
3. Appliance description ����������������������� 11
4. Operation ��������������������������������� 11
4.1 Controls ___________________________________ 11
4.2 Start screen ________________________________ 12
5. Menu ������������������������������������� 12
6. Care �������������������������������������� 13
7. Troubleshooting ��������������������������� 13
INSTALLATION
8. Safety ������������������������������������ 14
8.1 General safety instructions ____________________ 14
8.2 Instructions, standards and regulations _________ 14
9. Appliance description ����������������������� 14
10. Installation �������������������������������� 14
10.1 Installation location _________________________ 14
10.2 Preparation ________________________________ 14
11. Electrical connection ������������������������ 15
12. Commissioning ���������������������������� 15
12.1 Initial start-up ______________________________ 15
12.2 Appliance handover _________________________ 15
13. Specication ������������������������������� 15
13.1 Data table _________________________________ 15
GUARANTEE
ENVIRONMENT AND RECYCLING