7
Temperatures
The Temperatures parameter enables you to
scan the following sensor temperatures of the
heat pump or heat pump system, comparing
the actual with the set temperatures,
the
relative humidity, etc.
.
– Outside temperature
– Actual room temperature
– Set room temperature
– Relative humidity
– Actual DHW temperature
– Set DHW temperature
– Actual heat pump return temperature
– System frost protection temperature
Note
No display, if the corresponding temperature
sensor is not connected.
Room temperature
With the Room temp. parameters you can
adjust the set room temperature for the day
and setback mode. Changing these parameters
results in a parallel offset of the heating curve.
The heating curve, room temperature
and heating program parameters are
not shown at the WPMi heat pump manager,
if the FEK is pre-selected for a specific
heating circuit.
Adjustments at control level 2 for users and contractors
Open the control flap
ROOM T
SET DAY
SET DAY
SET DAY
SET HIGHT
SET HIGHT
SET HIGHT
ROOM T
BACK
To Next Page
Loading...
