WWW.STIEBEL-ELTRON.COM LWZ 170 E PLUS / LWZ 370 PLUS | 9
6. Troubleshooting
6.1 Fault analysis
26�04�15�0060
If the appliance detects a fault, a flashing fault symbol (spanner)
is displayed, possibly together with a fault number.
The appliance differentiates between a fault, where the appliance
continues to operate with limited functionality, and a blocking
fault, where both fans are stopped.
In the event of a blocking fault, the settings and read-out menus
are also switched off and access is restricted to the service menu.
The appliance remains in this fault condition until the problem has
been resolved. The appliance then resets itself (auto reset) and
standard mode is displayed again.
6.2 Fault codes
Non-blocking fault
26�04�15�0061
If the appliance detects a non-blocking fault code, it continues to
operate with limited functionality. Non-blocking faults are dis-
played with the fault symbol (spanner).
Blocking fault
D0000036353
If the appliance detects a blocking fault code, it stops. The per-
manently illuminated display shows the fault symbol (spanner)
together with a fault code.
Notify a qualified contractor, who can correct the fault.
A blocking fault cannot be resolved by briefly disconnecting the
appliance from the power supply. The fault itself must first be
rectified.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-000000).
To Next Page
Loading...
