STIEBEL ELTRON LWZ 8 CS Premium User Manual



w LWZ 5-8 CS Premium / 9
07:00 - 20:00
- -:- - - - -:- -
- -:- - - - -:- -
26�04�01�0299
MONDAY
MAIN MENU
PROGRAMS
HEATING PROGRAM HC
HEATING CIRCUIT 1
In this example, only one switching time pair has so far been
programmed. For switching time pairs 2 and 3, short dashes are
displayed instead of times. These switching time pairs are still
empty. Select one of the free switching time pairs with „OK“ to
reach the area where you can set the associated start and end
time. Pressing „OK“ brings up the display shown below. Set the
required time.
END
- -:- -
- -:- -
TIME TIME
START
26�04�01�0302
MAIN MENU
PROGRAMS
HEATING PROGRAM HC
SETTINGS
Times can be entered in intervals of 15 minutes. Confirm your
entry with OK.
Periods around midnight
Assume, for example, you want heating mode to be enabled from
22:00h for four hours every Wednesday evening. However, since
the day ends at 00:00h, two switching time pairs are necessary for
the required program. First, program the period 22:00 to 00:00h
for Wednesday, then 00:00 to 02:00h for Thursday.
Deleting a switching times pair
Select the pair of switching times you want to delete. Go to the
start time change. Turn the scroll wheel to reduce the time. If you
reach 00:00 and continue to make a rotation, the pair of switching
times is removed. The previously shown display appears, i.e. das-
hes instead of numbers. Confirm again with OK.
 DHW PROGRAM
Here, you can set the periods when DHW is heated with reference
to the set day temperatures. In the other phases, the set night
temperatures are followed. You can select the set values for day
and night mode as described in the DHW chapter.
Example: You want to heat up DHW daily at two different times, i.e.
from 22:00 to 05:00h the following day, and then again from 08:00
to 11:00h. Since the day begins at 00:00h, begin programming
at 00:00h. The first pair of switching times runs from 00:00 to
05:00h. The second pair of switching times starts at 08:00h and
ends at 11:00h. The third switching time pair runs from 22:00 to
24:00h.
The pairs of switching times should be selected so that the DHW
cylinder can be completely heated up between the start and stop
times (at least 3 hours).
 FAN PROGRAM
The setting is made as for the central heating and DHW programs.
 HOLIDAY PROGRAM
During the holidays, if nobody is in the house, central heating,
DHW and ventilation are not required in their full scope. All set
temperatures are set to match the set values of the standby func-
tion. Define the first and last days of the holiday. At the end of the
holiday, the appliance runs according to the set programs again.
 HOLS BEGINNING
 DAY
 MONTH
 YEAR
 HOUR
 MINUTE
 HOLIDAYS ENDING
 DAY
 MONTH
 YEAR
 HOUR
 MINUTE
 PARTY PROGRAM
Under this parameter you can extend day mode for several hours.
Enter the start and end time of your party. Times can be set that
go beyond the end of the day the party starts.

STIEBEL ELTRON LWZ 8 CS Premium Specifications

General

Brand	STIEBEL ELTRON
Model	LWZ 8 CS Premium
Category	Household Appliance
Language	English