STIEBEL ELTRON WWK 302 H - Siting the Appliance

12 | WWK222-302 H www.stiebel-eltron.com
INSTALLATION
Preparations
Note
For details on sounds emissions, see chapter "Specifica-
tion/ Data table".
9.4 Siting the appliance
 Carefully undo the cardboard packaging at the clips.
D0000034797
1
1 Cardboard packaging clips
The appliance is secured to the pallet with metal brackets and
screws. The metal brackets are hooked on to the feet underneath
the floor plate of the appliance.
1.
2.
D0000034798
1
1 Metal bracket fixing screw
 Remove the fixing screws of the metal brackets from the
pallet.
 Push the metal brackets a little towards the cylinder centre to
unhook them from the appliance feet.
 Pull the metal brackets out from underneath the appliance.
!
Material losses
Take note of the appliance's weight and centre of gravity.
 Slightly tip the appliance and carefully roll the appliance off
the pallet.
 Position the appliance in the final installation site.
!
Material losses
The appliance must be positioned vertically to avoid
damage.
The feet under the floor plate of the appliance are
height-adjustable.
 Level the appliance horizontally using the height-ad-
justable feet.
D0000039043
9.4.1 Minimum clearances
 Maintain the minimum clearances.
Connecting with straight pipe adapters
≥150
≥350
≥400
≥400
≥500
D0000029620
Note
If you install the supplied bracket pipe adapters on the
"Cold waterinlet" and "DHW outlet" connections, you can
reduce the minimum clearance at the back of the appli-
ance described in the following installation.