Stiga 2021 Edition PARK 320 P User Manual

WORKSHOP MANUAL



EDITION

PAGE
28 / 124 
2. Unscrew the two nuts (2) and remove the hood
(1) by sliding it off the support hinge (3).
When assembling, pay attention to position the
plastic washer (4) on the side of the support
(3).
 
 The front casing (1) consists of two el-
ements connected together by a screw, located
on the left side. The following procedure provides
for the removal of the two assembled elements,
which can be separated later.
1. Unscrew the right screw (2)










Stiga 2021 Edition PARK 320 P Specifications

General

Model	PARK 320 P
Edition	2021
Category	Lawn Mower
Cutting Height Range	25 - 85 mm
Transmission	Hydrostatic
Drive	Rear-wheel drive
Warranty	2 years
Steering	Articulated
Wheels	Front 16", Rear 16"