11
ENGLISH
GB
To replace the blade, undo the screw (fig. 27). Fit
the new blade so that the stamped logo is turned up
facing the blade holder (not facing the grass).
Reinstall asillustrated.Tighten the screw properly.
Tightening torque 40 Nm.
When replacing the blade, the blade screw should
also be replaced.
The guarantee does not cover damage to the blade,
blade holder or engine caused by running into
obstacles.
When replacing the blade, blade holder and blade
screw, always use genuine spare parts. Non-
genuine spare parts can entail a risk of injury or
damage, even if they fit the machine.
SHARPENING THE BLADES
Sharpening of the blades must be done by wet
method grinding, using a whetstone or a
grindstone.
For safety reasons, the blades should not be
sharpenedonanemerywheel.Averyhigh
temperature could cause the blades to become
brittle.
Once the blade has been sharpened, it
must then be balanced to avoid
vibration damage.
STORAGE
WINTER STORAGE
Empty the fuel tank. Start the engine and let it run
until it stops. The same petrol must not remain in
the tank for more than one month.
Tip up the mower and unscrew the spark plug.
Pour a tablespoon of engine oil into the spark plug
hole. Pull out the starter handle slowly so that the
oil is distributed in the cylinder. Screw in the spark
plug.
Thoroughly clean the mowerand store it indoors in
a dry place.
SERVICING
Genuine spare parts are supplied by service
workshops and by many dealers.
To Next Page
Loading...
Need help?
General
