Machi-
nes with
quick-
release
supports
1 grease nipple
Use a grease gun lled with
universal grease
Pump until the grease seeps out.
41:F
9.15 Fuses (40, 41)
If any of the faults listed below occurs, replace the
relevant fuse (40, 41).
Fault Fuse
The engine does not start or starts
and stops immediately. The battery is
charged.
10 A
The rear accessory and the electrical
cutting height adjustment does not
work.
20 A
All electrical functions are out of ope-
ration.
The battery is charged.
30 A
10 ASSISTANCE AND REPAIRS
This manual provides all the necessary informa-
tion to run the machine and for correct basic main-
tenance operations which can be performed by
the user. Any regulations and maintenance opera-
tions not described herein must be carried out by
your Dealer or Authorized Service Centre, which
have the necessary knowledge and equipment
to ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Before performing any servicing ope-
rations:
a.
b. Apply the parking brake.
c.
d. Remove the key from the ignition.
Authorized service workshops carry out gua-
ranteed repairs and maintenance. Always use
genuine spare parts.
Genuine STIGA SpA spare parts and
accessories have been designed spe-
-
ase remember that non-genuine spare
parts and accessories have not been
The use of non-genuine spare parts
and accessories could adversely af-
fect machine operation and safety. STI-
GA SpA shall decline all liability in the
event of injuries or damages caused by
such parts.
Genuine spare parts are supplied by
authorized assistance workshops and
dealers.
It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance and
safety device inspection.
To Next Page
Loading...
