EN - 16
7.2.1 Refuelling
To refuel:
1.
25).
2.
3. Refuel being careful not to
4.
5.
IMPORTANT Do not drip petrol onto
the plastic parts to avoid ruining them.
In the event of accidental leaks, rinse
immediately with water. The warranty does
not cover for damage to plastic parts of the
bodywork or the engine caused by petrol.
7.2.2 Emptying the fuel tank
NOTE Fuel is perishable and should
not remain in the tank for more than 30
days. Empty the fuel tank before storing the
machine for long periods of time (chap. 9).
Allow the engine to cool
before emptying the fuel tank.
1.
surface, in the open air.
2. Place a suitable container under
3.
4. Open the fuel tap (if provided)
5. Collect the fuel in a suitable container.
6.
7. Close the fuel tap (if provided).
The next time the machine is used,
check that there are no fuel leaks from
the tubes, fuel stopcock or carburettor.
7.3 CHECK, TOP UP, DRAINING
NOTE The type of oil to use is
given in the engine manual.
IMPORTANT The machine is delivered
to the client without engine oil.
IMPORTANT Follow all the
instructions in the engine manual.
7.3.1 Check/top-up
Always check the oil level before use.
•
.
Do not overll as this could cause
the engine to overheat. If the oil level
exceeds the “MAX” mark, drain until
the correct level is achieved.
7.3.2 Draining
The oil may be very hot if removed
just after the engine has been switched
o. Consequently allow the engine to
cool down for a few minutes before
proceeding to drain o the oil.
• Type "I":
1.
2. Place a suitable container under
3.
4. Collect the oil in a suitable vessel.
5.
6.
7.
• Type "II":
1.
2.
far as possible into the hole.
3.
• Type “III”:
1.
2. Place a suitable container under
3.
4.
5. Bend the extension tube and drain
the oil into a suitable container.
To Next Page
Loading...
Need help?
General
