6
31. Warning: Read the instructions before op-
32. Warning:
-
33. Danger! Ejected objects: Do not operate
the grass catcher being in place.
34. Danger! Ejected objects:-
35. Danger! Machine rollover: Do not use this
36. Danger! Dismemberment:
37. Danger of cutting yourself. Cutting
near or under the opening of the cutting
38. Warning!
39.
2.4 REGULATIONS FOR TOWING
-
the instructions provided.
41.
NOTE The images corresponding to the texts
in chapters 3 et seq., can be found on pages iii et
seq. of this manual.
3. UNPACKING AND ASSEMBLY
-
-
IMPORTANT The machine is supplied without
engine oil or fuel. Before starting up the engine,
fill with oil and fuel following the instructions given
in the engine manual.
WARNING! Unpacking and completing
the assembly should be done on a flat and
stable surface, with enough space for mov-
ing the machine and its packaging, always
making use of suitable equipment.
3.1 UNPACKING
NOTE To avoid damaging the cutting-means
assembly when getting the machine down from
the pallet, take it to the maximum height and be
very careful.
Hydrostatic transmission:
-
engage lever should be put in position «B»
-
3.2 FITTING THE STEERING WHEEL
• Steering wheel Type “I” (Fig. 3.1)
seat.
-
through to the opposite side.
NOTE To avoid damaging the steering wheel,
use a punch or a screw-driver of the same size
as the pin when hammering it in the last part.
• Steering wheel Type “II” (Fig. 3.2)
To Next Page
Loading...
Need help?
General
