16
Raise and release the upper part of the bonnet
-
To replace the bonnet, repeat the above proce-
dure in reverse order.
6.3.5 Replacing a fuse (Fig. 6.8)
-
cuits of the electronic circuit board. When it
-
fuse.
IMPORTANT A blown fuse must always be
replaced by one of the same type and ampere
rating, and never with one of another rating.
6.3.6 Removing, replacing and
reassembling of cutting means
WARNING! Always wear strong protec-
tive gloves to handle the cutting means.
WARNING! Always replace damaged or
bent cutting means; never attempt to repair
them! ALWAYS USE ORIGINAL CUTTING
MEANS!
-
chine.
-
-
IMPORTANT Cutting means should be
replaced in pairs, especially when there are
marked differences in wear.
6.3 INTERVENTIONS ON THE MACHINE
6.3.1 Aligning the cutting-means
assembly (Fig. 6.3)
-
-
6.3.2 Replacing the wheels (Fig. 6.4)
NOTE If you have to replace one or both rear
wheels, make sure that any differences in their
external diameter does not exceed 8-10 mm; on
the contrary, you must adjust the cutting-means
assembly alignment to prevent uneven mowing.
IMPORTANT Before remounting the wheel,
apply grease to the axle. Put the snap ring (1)
and shoulder washer (2) back in place.
6.3.3 Repairing or replacing tyres
6.3.4
• Type “I” bulbs (incandescent) (Fig. 6.5)
• Type “II” bulbs (LED) (Fig. 6.6)
-
• Type “III” bulbs (LED) (Fig. 6.7)
To Next Page
Loading...
Need help?
General
