11
Mechanical transmission
-
WARNING! The pedal has to be re-
leased gradually, as a sudden engage-
ment may cause the vehicle to tip over
and the driver to lose control.
the throttle and gear lever. To change gear,
IMPORTANT Gear must only be engaged
when the machine has stopped.
Hydrostatic transmission:
-
WARNING! Drive must be engaged
as described below (see 4.32) to prevent
sudden engagement from causing tipping
up and loss of control of the vehicle, par-
ticularly on slopes.
5.4.3 Braking
-
chine until it stops.
Hydrostatic transmission:
-
5.4.4 Reverse
IMPORTANT Reverse must only be engaged
when the machine has stopped.
IMPORTANT To proceed in reverse gear with
the cutting means engaged, it is necessary to
press and hold the consent button (see 4.7) so
as not to cause the engine to stop.
Mechanical transmission
Hydrostatic transmission:
-
5.4.5 Grass cutting
Model 102
-
-
ground.
-
WARNING! This should always be
performed on both wheels, position-
ing them at the same height WITH THE
ENGINE OFF AND CUTTING MEANS
DISENGAGED.
-
To Next Page
Loading...
Need help?
General
