9
The mower’s blade housing is
dirty underneath
Clean the blade housing so as to
to the grass box
3. Mower struggles to cut grass
The blade is not in good
conditions
Sharpen the blade or replace it
For any doubts or problems, please do not hesitate to contact your
.
5) If accessing the lower part is necessary, only tilt the machine on the
.
6) Do not drip petrol onto the plastic parts of the engine or the machine
-
by petrol.
4.1 Blade maintenance
that has the most appropriate tools.
On this machine must be used blades with code shown in the table on
page 2.
time by others, with similar interchangeable and operating safety features.
Reassemble the blade (2) with the code facing the ground, following the
steps indicated in the illustration.
Tighten the central screw (1) using a torque wrench set to 35-40 Nm.
4.2 Battery recharging (where applicable)
• Electric key ignition models
the instructions in the battery maintenance manual.
Do not connect the battery charger directly to the engine terminal. It is
not possible to ignite the engine using the battery charger as a power
source, as it may get damaged.
If you do not use the lawnmower for a long period of time, disconnect
• Electric push-button ignition models
Read the engine instruction manual for instructions regarding autono-
my, recharging, reinstating and maintenance of the battery.
5. ENVIRONMENTAL PROTECTION
.
– Try not to cause any disturbance to the surrounding area.
– Scrupulously comply with local regulations for the disposal of waste ma-
terials after mowing.
– Seguire scrupolosamente le norme locali per lo smaltimento di imballi,
Scrupulously comply with local regulations for the disposal of packaging,
this waste must not be disposed of as normal waste, it must be separated
recycled.
– -
regulations in force.
6. DIAGNOSTIC
What to do when ...
Source of problem
1. Petrol mower does not work
There is no oil or fuel in the
engine
not in working order
Clean the spark plug and the
replace
The fuel has not been emptied
by the mower at the end of last
season
the carburetor side
2. Cut grass is not blown into the grass box
Sharpen, the blade or replace it.
Check the guides which direct the
grass towards the grass box
To Next Page
Loading...
Need help?
General
