To Next PageTo Next Page
Need help?Do you have a question about the Stiga SILEX 75-G and is the answer not in the manual?
The control is used to start the rotor for reverse when the engine is running.
The control is used to start the rotor for forward motion when the engine is running.
The control determines the engine's rpm and has start and stop positions.
Always check the oil level before starting the engine.
The screw is removed when used engine oil is to be drained.
Nobody must be close to the dangerous rotors during operation.
Nobody must be close to the dangerous cutting discs during operation.
Always check the oil level before starting. Otherwise there is a risk of serious engine damage.
Open the fuel cock. Put the choke in position 'CHOKE'. Set the throttle.
Tip the rotary cultivator back slightly so that the rotor is above ground.
Change oil after 2 hours of operation and subsequently every 25 hours or season.
Troubleshoot common issues like difficult starting or uneven running.
General
