3
EN
be taken to designated facilities for recycling
and disposal.
1.4. STOPPING AND TURNING OFF THE ROBOT
LAWN MOWER IN SAFE CONDITIONS
OBLIGATION:
maintenance operation.
1. Press the “STOP” button (Fig. 1.A) to stop the robot lawn
mower safely and open the protective cover (Fig. 1.B).
2.
for the LED on the same button to go out.
3. Only after the LED has gone out (Fig. 1.E), remove the
in safe conditions.
4. Close the protective cover (Fig. 1.B).
5.
safe condition.
2. INSTALLATION
WARNING:
the safety devices installed.
product please contact a STIGA dealer.
(A) Charging base, (B) Charging base Power Supply Unit, (C)
(E) Separate Satellite Reference Station Installation Bracket
, (F) Separate Satellite Reference Station Installation Power
Supply (optional), (G) 5 m or 15 m extension cords, (H) Mobile
device (not included).
2.1. VERIFICATION OF THE INSTALLATION
2.1.1. GARDEN ASSESSMENT:
• Assess your garden for virtual perimeters, obstacles, and
areas to be excluded.
• Level the ground to prevent puddles from forming after
a rainfall.
2.1.2. CHECKS FOR THE INSTALLATION OF THE
THE SATELLITE REFERENCE STATION:
ELECTRICAL HAZARD:
It is absolutely necessary to provide an
ELECTRICAL HAZARD:
The circuit provided must be protected by
activation current not exceeding 30 mA.
ELECTRICAL HAZARD:
electrical outlet if the plug or the cable is
damaged.
Do not connect or touch a damaged cable
supply.
live parts.
1.
the charging base. The charging base must be installed
in a location that can be reached by the satellite signal,
preferably in an area of the garden where the sky is fully
visible.
2. In the area in front of the charging base there must be
a stretch of land at least 2 m wide and at least 3 m long
without obstacles.
3. If the sky is not completely visible from the charging base
installation point, the satellite reference station must be
installed in another area
NOTE: The sky is considered fully visible when clear at
an angle of at least 120 degrees in all directions.
WARNING:
belong to the product must remain outside the
cutting area to maintain their distance from
hazardous moving parts and prevent damage
live parts.
4. Set up the installation area of the power supply unit in
such a way as to prevent it from being submerged by
water under all weather conditions. Preferably install in a
closed room and protected from weather conditions, in a
location not easily accessible by unauthorised persons.
2.1.3. CHECKS TO DEFINE THE VIRTUAL PERIMETERS:
1. Check that the maximum slope of the work area is less
than or equal to 45% or 50% depending on the model
perimeters, observe the rules shown in Fig. 4.
WARNING:
slope of 45% or 50% depending on the model.
To Next Page
Loading...
