6
EN
• “ALARM” luminous icon (Fig. 1.N): it is used to display
alarm statuses.
• “BATTERY” luminous icon (Fig. 1.O): it is used to display
the battery charge level.
NOTE: For a more detailed description of the commands
listed above, please refer to the Comprehensive Manual.
3.3. CHARGING BASE OPERATION
The charging base is equipped with a warning light (Fig. 8.N)
which lights up as shown below:
•
robot is on the base.
• Fixed warning light: the robot lawn mower is not connected
to the charging base and the antenna signal is correctly
transmitted.
• Flashing light: the charging base is not set up correctly,
or a charging base fault has been detected. Refer to the
Comprehensive Manual.
3.4. BATTERY CHARGING
The "BATTERY CHARGING" procedure allows to recharge
the robot lawn mower manually.
1. Position the robot lawn mower on the charging base
(Fig. 9.R).
2. Slide the robot lawn mower onto the charging base, until
the charging connector is engaged (Fig. 9.S).
3. Press the “STOP” button (Fig. 9.A) to open the cover
(Fig. 9.B) and access the control panel (Fig. 9.C).
4. Turn the robot lawn mower on with the “ON/OFF” button
(Fig. 9.E).
5.
the robot lawn mower is charging.
6. Close the cover (Fig. 9.B).
7. Leave the robot lawn mower to charge for at least the
time shown in Par. 2.3.3.
NOTE: Charging the battery before winter storage should
be carried out as shown in Par. 4.3.
3.5. CUTTING HEIGHT ADJUSTMENT
Follow APP wizard to adjust the cutting height.
CAUTION:
the cutting height.
NOTE: The length of the grass cut by the robot lawn
mower must not exceed 10 mm.
4. MAINTENANCE
CAUTION:
Only use original spare parts.
CAUTION:
the safety devices installed.
CAUTION:
Danger of cutting hands.
Use protective gloves to avoid cutting your
hands.
CAUTION:
Danger of dust in the eyes.
Use safety glasses to avoid the danger of
dust in the eyes.
WARNING:
electrical parts.
BAN:
BAN:
To avoid irreversible damage to the electrical
BAN:
and electronic components.
BAN:
Do not use solvents or petrol so as not to
damage varnished surfaces and plastic parts.
To Next Page
Loading...
