64
SWP 355
EN
NOTE
the ground. A too high pressure does not
leads to an increase in the pushing resistance
and the wear of the device.
• Set the required level:
• Push the lever (1) into the desired position
(Level 1-3) to the left or right.
» Lift the machine slightly by the handle. This
will make it easier to adjust the height.
• Operate the device via the telescopic bracket
with both hands.
• Push the device forward at normal walking
speed.
•
Section of this operating manual.
• Empty the sweeping container after each use.
• Empty the sweeping container at regular
intervals to achieve a proper sweeping result.
1. Bring the telescopic sliding bracket (1) into
the vertical position.
»
released for removal from the device. This is
2. Pull the sweeping container upwards by the
handle (2).
3. Empty the sweeping container completely.
» Make sure that the enclosure sides are free
of dirt.
4. Place the empty sweeping container on
the device and bring the telescopic sliding
bracket back into the operating position.
» In the operating position of a telescopic
locked.
1
2
3
1
1
2
To Next Page
Loading...
Need help?
General
