Do you have a question about the Stiga BP 375 and is the answer not in the manual?
Explains how to interpret symbols and special formatting within the manual.
Details on how figures, titles, and paragraphs are referenced throughout the document.
Covers operator training, personal protective equipment (PPE), and preparation of the work area and machine.
Details safe operating practices, environmental considerations, and handling of potential hazards during use.
Outlines the machine's purpose, intended use, and examples of improper usage.
Explains the meaning of various safety symbols found on the machine for user caution.
Details the product identification label and describes the main components of the machine.
Details the process of unpacking and assembling the machine's components, including tubes and handgrip.
Explains the function and operation of the throttle control lever, adjuster, and engine stop lever.
Describes the choke control, primer button, and manual start handle for engine ignition.
Covers essential pre-operation preparation steps for efficient and safe work.
Outlines crucial safety checks to perform before operating the machine.
Detailed steps for starting the engine, including cold and warm starts, and harness usage.
Guidance on operating the machine, adjusting speed based on material, and general usage advice.
Instructions for safely stopping the engine and procedures for after-use care.
Provides general maintenance guidelines, safety precautions, and instructions for preparing the fuel mixture.
Details the safe procedure for refuelling and cleaning the machine and engine.
Covers less frequent maintenance tasks like cleaning the air filter, checking the spark plug, and carburetor tuning.
Provides instructions and recommendations for storing the machine properly for extended periods.
Guidelines for safely handling and transporting the machine, including vehicle transport.
Information on seeking assistance and carrying out repairs, emphasizing authorized service.
Details the scope of the warranty coverage and exclusions for the machine.
A table summarizing maintenance tasks, their frequency, and relevant paragraphs for reference.