Action Result
Release the throttle
the idle position.
The rotor rotates
expels little air.
Move the throttle regulator
The engine stops.
The rotor stops and
not expel air.
If any of the results fail to match
the indications provided in the tables
below, do not use the machine! Take
it to a service centre to be checked
and repaired if necessary.
6.3
IMPORTANT A label (g. 2) is placed on the
machine that summarizes the start up main steps.
The label is a quick guide and it does not
replace the procedures specied below.
1.
2.
IMPORTANT To avoid breaking the starter
rope, do not pull the whole length of it or let
it slide along the edge of the cable guide
hole. Release the starter handgrip gradually,
to prevent it ying back uncontrollably.
IMPORTANT Never wind the
starter cable around your hand.
6.3.1 Startup from cold
A “cold” start of the engine means
starting it after at least 5 minutes from when
it was switched off or after refuelling.
1.
2.
3.
4.
5.
6.
7. Pull the starter grip until the
8.
9.
10. Move the throttle regulator lever (Fig.
IMPORTANT If the choke handgrip is
pulled repeatedly with the starter on, it may
ood the engine and make starting dicult.
If the engine oods (see paragraph 14.5).
6.3.2 Warm start
1.
6.3.3 Using the harness straps
to suit the operator’s height and stature.
1.
2.
3.
4.
to the control handgrip support (Fig.
6.4 WORKING
When performing work, the machine
must always be held rmly with the right
hand on the control handgrip (Fig. 15).
6.4.1
–
–
–
To Next Page
