6.4.2 Advice for operation
It is possible to adjust the position and angle
To adjust it:
–
– To adjust the angle, bend the control
–
–
IMPORTANT Stop the machine (par.
6.5) when moving between work areas.
6.5 STOP
1. Release the throttle control lever (Fig.
2.
3.
It takes a few seconds for the rotor to
stop after the machine has been turned o.
The engine may be very warm
immediately after it is shut o. Do not
touch. The engine can cause burn injuries.
IMPORTANT Stop the machine (par. 6.5) and
remove the spark plug cap (Fig. 9.F ) whenever
the machine is unused or left unattended.
IMPORTANT Stop the machine (par.
6.5) when moving between work areas.
6.6 AFTER USE
•
•
storing in an enclosed space.
•
•
the authorised service centre.
7. ROUTINE MAINTENANCE
7.1 GENERAL INFORMATION
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
Prior to carrying out any
maintenance operation, you need to:
• Stop the machine;
• Remove the spark plug cap (Fig. 9.F);
• Wait until the engine is suciently cold;
• Read the relevant instructions;
• Use suitable clothing, protective
gloves and goggles;
•
• The use of non-genuine spare parts and
•
•
be replaced and never repaired.
IMPORTANT Any maintenance and
adjustment operations not described in
this manual must be carried out by your
dealer or Authorised Service Centre.
7.2 PREPARING THE FUEL MIXTURE
To Next Page
Loading...
