EN - 6
G.
4. ASSEMBLY
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
Unpacking and completing the
assembly should be done on a at and
stable surface, with enough space for
machine handling and its packaging,
always making use of suitable equipment.
Do not use the machine until all the
indications provided in the “ASSEMBLY”
section have been carried out.
4.1 ASSEMBLY COMPONENTS
4.1.1 Unpacking
1.
2.
box, including these instructions.
3.
4.
5.
4.1.2 Assembling the blower tube
and control handgrip
1.
2.
3. Insert the control handgrip support (Fig.
4. Fasten the control handgrip in place (Fig.
5. Thread the cable through the
6.
7.
4.1.3 Removing blower tubes
IMPORTANT Stop the machine (par. 6.5)
whenever the blowing tube is removed.
–
–
5. CONTROLS
5.1 THROTTLE CONTROL LEVER
possible to control the speed of the rotor.
or less pressure on the throttle control.
the throttle control as far as possible.
5.2
ENGINE STOP LEVER
1. Used to start and stop the engine.
If the lever is positioned in other
directions, the engine can be started.
2.
in the desired position. The rotor rotation
To Next Page
Loading...
