WORKSHOP MANUAL
T...102/122 - TC...102/122
Map of functional units
NOTE The lower panel/board group guard, xed by
two nuts, must be removed to carry out this o pe ration.
Use a screwdriver to remove the at battery (1).
Only use 3 Volt 24 mm Ø batteries of types CR 2450
or CR 2430.
When tting the new battery make sure that the end
marked «+» faces towards the check spring.
Validity
General informations
Related topics
---
REPLACING THE CLOCK’S BUFFER BATTERY
CHAPTER REVISION FROM ... PAGE
7.19 0 2018 1 of 1
To Next Page
Loading...
