EasyManuals Logo

Stiga TRE 0702 User Manual

Stiga TRE 0702
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
«MAX» notch on the dipstick (3).
g) Close  the  cap  (1)  again  and  clean  up  any 
traces of oil that was possibly spilt.
IMPORTANT
The engine holds a maxi-
mum of 1.2 litres of oil. Topup gradually adding
small amounts of oil at a time; check that the oil
level never exceeds the «MAX» notch on the
dipstick.
6.4
CLEAN SILENCER AND ENGINE
Silencer  must  be  cleaned  when  the  engine  is 
cold.
a) Use  a  jet  of  compressed  air  to  remove  any 
debris and dirt that could cause a fire from the 
silencer and its protective cover.
b) Make sure that the cooling air intakes (1) are 
not blocked.
c) Clean  the  plastic components  with  a  sponge 
(2) soaked in water and detergent.
6.5
AIR FILTER MAINTENANCE
a) Clean the area around the filter cover (1).
b) Remove the cover (1) by unscrewing the two 
knobs (2 - TRE0701 - TRE0801), or by press-
ing the tabs (2a - TRE0702).
c) Remove the filtering element (3a + 3b).
d) Remove  the  pre-filter  (3b) from  the  cartridge 
(3a).
e) Tap the cartridge (3a) on a solid surface and 
blow it from the inside with compressed air to 
remove dust and debris.
f) Wash the sponge pre-filter (3b) with water and 
detergent and leave it to dry in the air.
IMPORTANT
Do not use water, petrol,
detergents or any other products to clean the
cartridge.
IMPORTANT
The sponge pre-filter (3b)
must NEVER be oiled.
g) Clean the inside of the filter housing (4) from 
dust and debris, making sure to block the inlet 
duct with a rag (5) to prevent them from enter-
ing the engine.
h) Remove the rag (5), install the filtering element 
(3b + 3a) in its housing and refit the cover (1).
6.6
SPARK PLUG SERVICE
a) Remove the spark plug (1) using a spark plug 
socket wrench (2).
b) Clean  the  electrodes  (3)  with  a  metal  brush 
and remove any carbonaceous build-up.
c) Using  a  thickness  gauge  (4),  check  for  the 
right  gap  (0.6  -  0.8  mm)  between  the  elec-
trodes.
d) Install  the  spark  plug  (1)  and  tighten  with  a 
socket wrench (2).
Replace the spark plug if the electrodes are burnt 
or if the porcelain is broken or damaged.
WARNING!
Fire hazard! Do not check
the ignition system with spark plug re mo-
v ed.
IMPORTANT
Use only spark plugs of the
recommended type (see 8.1).
6
EN

Other manuals for Stiga TRE 0702

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stiga TRE 0702 and is the answer not in the manual?

Stiga TRE 0702 Specifications

General IconGeneral
BrandStiga
ModelTRE 0702
CategoryEngine
LanguageEnglish

Related product manuals