Edition Manual Chapter Page
2008-05-19 Workshop Manual, Stiga Villa/Ready 2 Chassis and Body 3
2. Remove the screws for the top cover.
If applicable, remove also the following:
• The bullet from the throttle handle by twist-
ing and pulling it simultaneously.
• The ignition switch nut. To aviod damage
at the plastic cover, use a 22 mm ring
wrench.
• The cutting heigth switch by pressing its
locking tabs at the underside.
3. Dismantle the front cover by unscrewing the
two screws at the under side.
4. Unhook the return spring.
To Next Page
Loading...
