Specifications
Engine
STIHL single cylinder two
024
Displacement:
Bore:
Stroke:
024 S
Displacement:
Bore:
Stroke:
Max. engine speed
with
cutting attachment:
Ignition System
Principle:
Ignition
timing:
Spark
plug (suppressed):
Fuel/Oil System
Carburetor:
Air
filter:
Fuel tank capacity:
Fuel
mixture:
Chain lubrication:
Oil tank capacity:
-stroke engine
13,000
r. p.
m.
41.6 cm3
(2.54
cu.
in)
42
mm
(1.65 in)
30 mm (1.18
in)
44.3 cm3
(2.70
cu.
in)
42
mm
(1.65 in)
32 mm (1.32
in)
Electronic magneto ignition
2.1
mm
(0.083 in) before T. D.C.
at
8,000
r. p. m.
Bosch WSR 6
For
NGK BPMR 7A
Heat range 200
Electrode gap 0.5 mm
(0.02 in)
Spark
plug thread
M
14x1.25;
9.5 mm
(0.37 in) long
All position diaphragm carbu-
retor with integral fuel
pump
Flat, two-part wire mesh
element
0.47 L (1 US pt)
See chapter "Fuel"
Speed controlled
plunger-type
oil pump
0.32 L (0.67 US
pt)
Weight
without bar and
chain: 4.8 kg (10.54
lb)
Cutting Attachment
Recommended cutting attachments for compliance
with
§ 4.12 of ANSI Standard B 175.1-1985 (see page 12 of this
Manual):
STIHL reduced kickback bar (with green label):
for 3/8" Picco
pitch and 0.325" pitch:
Rollomatic with
sprocket nose
40, 45 or 50 cm (16, 18 or 20 in)
STIHL low kickback chain* (with green label):
9.32 mm (3/8") Picco-Micro
1(63
pm 1) or
8.25 mm (0.325")
Topic-Micro
1
(26
tm
1)
Chain
sprocket:
8-tooth for 3/8" Picco-pitch or 7-tooth for 0.325" pitch
Other cutting attachments available for this
powerhead
are:
STIHL
yellow-labeled bar:
for 0.325" pitch:
Rollomatic "S" with sprocket nose
40, 45
or
50
cm
(16, 18
or
20 in)
Duromatic with stellite tipped
nose
40, 45 or 50 cm (16, 18 or 20 in)
STIHL yellow-labeled chain:
for 0.325" pitch: Topic-Micro (26 TM), Topic-Super (26 TS)
Since
new bar/chain combinations may be developed
after publication of this Manual, ask your STIHL dealer for
the latest STIHL recommendations.
In
order to comply with the kickback performance
require-
ments of
§
4.12
of
ANSI Standard B 175.1-1985, do not
use
replacement
saw chain unless it
has been designated
as
meeting the ANSI
§
4.12 requirements
on
this specific
powerhead, or has been designated as "low kickback"
saw chain*
in accordance with the ANSI B
175-1985
standard.
"See definition of
"low kickback chain" on p.12 of this Manual. 47
To Next Page
Loading...
