32
Starting
Before starting
your saw,
make
sure you
have
a
firm foot-
hold and check that the
saw
chain
is not touching the
ground or any other obstacles. Bystanders must be kept
well clear of the general work
area of the saw.
See "Master Control" for full description of its functions.
1. Preparations
1.1 Engage
the chain brake by pushing the hand guard (1)
towards the bar
nose.
Note: You will hear a
definite click when the
brake
en-
gages.
1.2 Adjust controls
If the engine is cold: Press down throttle trigger inter-
lock (2) and move Master Control lever (3) to H (Cold
Start).
If engine is warm: Press
down throttle trigger inter-
lock (2) and
move
Master Control lever (3)
to N
(Warm
Start).
Note: Also select this position if engine has been run-
ning
but
is still cold.
och
To Next Page
Loading...
